-
Dielectric strength up to 35,000 Volts per 0.1 inch
-
Fast acting, non-conductive cleaner
-
Penetrates quickly, fast drying and leaves no residue
-
RoHS compliance
-
Perfect for cleaning electrical equipment, contacts and plastics
DIRECTIONS
Isolate all electricity and allow hot surfaces to cool.
Make sure all stored power is drained from the system.
Shake can well before use.
Hold can 15cm to 20cm away from the surface and spray directly onto the electronic device or circuit board to eliminate and remove contaminants that may cause loss of electrical contact.
Tilt surface while cleaning and allow any excess cleaner to run off. Allow product to dry completely and thoroughly vent the system before restoring power.
PHYSICAL AND CHEMICAL PROPERTIES WITHOUT PROPELLANT Boiling Point (initial) 60℃
Solubility in Water Insoluble Extreme Cleaning Score 63.4% (ASTM D4488 – A2)
Dielectric strength 35,000 volts per 0.1 inch Percent Volatile 100%
Flash Point -23℃ Specific Gravity 0.66 Appearance/Odor Clear liquid / hydrocarbon odor
PACKAGING PRODUCTNAME UNIT CODE UNIT SIZE CASE SIZE
FAST DRYING CONTACT CLEANER
35001 360ML 12
K1, K2, K3 REGISTERED #145365
**NOTE The data contained herein are furnished for information only and are believed to be reliable. We cannot assume responsibility for the results obtained by others over whose methods we have no control. WD-40 Company specifically disclaims all warranties expressed or implied, including warranties of merchantability or fitness for a particular purpose, arising from sale or use of WD40 Company products and disclaims any liability for consequential or incidental damages of any kind. Including lost profits
Downloads: No
Warranty Details: